A parametric study of reservoir cooling for enhanced recovery by CO2 flooding

Zhenzhen Wang, Amey Khanzode, Russell Taylor Johns

Research output: Chapter in Book/Report/Conference proceedingConference contribution

4 Scopus citations

Abstract

Slim-tube experiments and analytical calculations show that minimum miscible pressure (MMP) can significantly decrease with a relatively modest reduction in temperature. Compositional simulation, however, is often made under isothermal conditions even though a prior waterflood may have reduced reservoir temperature in the swept zones of the reservoir. This paper examines how cooling by a prior waterflood can impact recovery during a CO2 flood by lowering the MMP in the swept zones. The results show that for the cases considered injection of cooler water can increase incremental oil recovery significantly owing to MMP reduction in the zones swept by the solvent. A parametric simulation study demonstrates how injection temperature, initial reservoir pressure, formation heterogeaneity, formation thickness, heat transfer with the over and under burden formations, and WAG ratio affect the incremental oil recovery. The simulations are conducted by performing a long waterflood of up to 2.0 PVI prior to CO2 injection. The water during the secondary recovery is injected at two temperatures for the 1-D and 2-D flow models. CO2 solvent is then injected continuously or in WAG at the same waterflood injection temperature. The increase in incremental recoveries (above what would have been obtained by a standard CO2 flood at original reservoir temperature) varied greatly depending on the flow dimension, initial reservoir pressure, level of heterogeneity, formation thickness, the degree of energy gain from the surroundings, and the injection temperature. Increases in recovery by CO2 flooding varied from a few %OOIP to over 20% with the highest recoveries occurring in 1-D flow. For the same flow dimension, the largest increase in recoveries is achieved when the MMP is sufficiently reduced by temperature so that an otherwise immiscible or near miscible flood becomes a multicontact-miscible (MCM) flood. The results demonstrate that including temperature variations in the simulations is important for floods that are near miscible as recoveries are most impacted in that region. Further, including temperature variations could be very important to improve the quality of history matches used to understand the reservoir. Lastly, we give a new MMP correlation for CO2 injection based on the most recent slim-tube data from the literature.

Original languageEnglish (US)
Title of host publicationSociety of Petroleum Engineers - SPE Annual Technical Conference and Exhibition, ATCE 2014
PublisherSociety of Petroleum Engineers (SPE)
Pages638-665
Number of pages28
ISBN (Electronic)9781634398879
Publication statusPublished - Jan 1 2014
EventSPE Annual Technical Conference and Exhibition, ATCE 2014 - Amsterdam, Netherlands
Duration: Oct 27 2014Oct 29 2014

Publication series

NameProceedings - SPE Annual Technical Conference and Exhibition
Volume1

Other

OtherSPE Annual Technical Conference and Exhibition, ATCE 2014
CountryNetherlands
CityAmsterdam
Period10/27/1410/29/14

    Fingerprint

All Science Journal Classification (ASJC) codes

  • Fuel Technology
  • Energy Engineering and Power Technology

Cite this

Wang, Z., Khanzode, A., & Johns, R. T. (2014). A parametric study of reservoir cooling for enhanced recovery by CO2 flooding. In Society of Petroleum Engineers - SPE Annual Technical Conference and Exhibition, ATCE 2014 (pp. 638-665). (Proceedings - SPE Annual Technical Conference and Exhibition; Vol. 1). Society of Petroleum Engineers (SPE).