Aeroacoustic source identification using frequency dependent velocity scaling

D. A. Quinlan, Michael H. Krane

Research output: Contribution to conferencePaper

6 Citations (Scopus)

Abstract

This paper discusses a method for identifying broadband aeroacoustic sources. The goal of the method is to experimentally derive the dependence of sound power level upon a characteristic velocity, and to use that dependence as an indicator of primary aeroacoustic processes. The analysis provides an identification of distinct frequency bands within which the variation in velocity dependence is relatively small. As such, each band is presumed to be controlled by different processes, and the set of likely processes is fixed according to the average velocity exponent value obtained. In principal, the method is applicable to any aeroacoustic source identification problem where a characteristic flow speed can be measured and systematically varied. Tests using synthesized acoustic data and measured jet impingement data were used to evaluate the performance of the method. The procedure was then applied to a small axial fen typical of those used to cool electronic systems. The results added support and insight into earlier experiments related to the radiation of high frequency (f > 2.5 kHz) noise. More specifically, fluid dynamic and acoustic measurements had shown that flow unsteadiness related to tip gap flows was the primary source of high frequency noise. The frequency dependent velocity scaling demonstrated that shifts in dominant aeroacoustic processes occur near 2.5 and 5-6 kHz. Additionally, the velocity scaling analysis indicated that the low frequency regime may be controlled by sources which are not compact.

Original languageEnglish (US)
DOIs
StatePublished - Jan 1 1996
Event2nd AIAA/CEAS Aeroacoustics Conference, 1996 - State College, United States
Duration: May 6 1996May 8 1996

Other

Other2nd AIAA/CEAS Aeroacoustics Conference, 1996
CountryUnited States
CityState College
Period5/6/965/8/96

Fingerprint

Aeroacoustics
Acoustics
Fluid dynamics
Acoustic noise
Frequency bands
Acoustic waves
Radiation
Experiments

All Science Journal Classification (ASJC) codes

  • Electrical and Electronic Engineering
  • Aerospace Engineering

Cite this

Quinlan, D. A., & Krane, M. H. (1996). Aeroacoustic source identification using frequency dependent velocity scaling. Paper presented at 2nd AIAA/CEAS Aeroacoustics Conference, 1996, State College, United States. https://doi.org/10.2514/6.1996-1743
Quinlan, D. A. ; Krane, Michael H. / Aeroacoustic source identification using frequency dependent velocity scaling. Paper presented at 2nd AIAA/CEAS Aeroacoustics Conference, 1996, State College, United States.
@conference{2066cce2575a4cc39241040a9794ca5c,
title = "Aeroacoustic source identification using frequency dependent velocity scaling",
abstract = "This paper discusses a method for identifying broadband aeroacoustic sources. The goal of the method is to experimentally derive the dependence of sound power level upon a characteristic velocity, and to use that dependence as an indicator of primary aeroacoustic processes. The analysis provides an identification of distinct frequency bands within which the variation in velocity dependence is relatively small. As such, each band is presumed to be controlled by different processes, and the set of likely processes is fixed according to the average velocity exponent value obtained. In principal, the method is applicable to any aeroacoustic source identification problem where a characteristic flow speed can be measured and systematically varied. Tests using synthesized acoustic data and measured jet impingement data were used to evaluate the performance of the method. The procedure was then applied to a small axial fen typical of those used to cool electronic systems. The results added support and insight into earlier experiments related to the radiation of high frequency (f > 2.5 kHz) noise. More specifically, fluid dynamic and acoustic measurements had shown that flow unsteadiness related to tip gap flows was the primary source of high frequency noise. The frequency dependent velocity scaling demonstrated that shifts in dominant aeroacoustic processes occur near 2.5 and 5-6 kHz. Additionally, the velocity scaling analysis indicated that the low frequency regime may be controlled by sources which are not compact.",
author = "Quinlan, {D. A.} and Krane, {Michael H.}",
year = "1996",
month = "1",
day = "1",
doi = "10.2514/6.1996-1743",
language = "English (US)",
note = "2nd AIAA/CEAS Aeroacoustics Conference, 1996 ; Conference date: 06-05-1996 Through 08-05-1996",

}

Quinlan, DA & Krane, MH 1996, 'Aeroacoustic source identification using frequency dependent velocity scaling', Paper presented at 2nd AIAA/CEAS Aeroacoustics Conference, 1996, State College, United States, 5/6/96 - 5/8/96. https://doi.org/10.2514/6.1996-1743

Aeroacoustic source identification using frequency dependent velocity scaling. / Quinlan, D. A.; Krane, Michael H.

1996. Paper presented at 2nd AIAA/CEAS Aeroacoustics Conference, 1996, State College, United States.

Research output: Contribution to conferencePaper

TY - CONF

T1 - Aeroacoustic source identification using frequency dependent velocity scaling

AU - Quinlan, D. A.

AU - Krane, Michael H.

PY - 1996/1/1

Y1 - 1996/1/1

N2 - This paper discusses a method for identifying broadband aeroacoustic sources. The goal of the method is to experimentally derive the dependence of sound power level upon a characteristic velocity, and to use that dependence as an indicator of primary aeroacoustic processes. The analysis provides an identification of distinct frequency bands within which the variation in velocity dependence is relatively small. As such, each band is presumed to be controlled by different processes, and the set of likely processes is fixed according to the average velocity exponent value obtained. In principal, the method is applicable to any aeroacoustic source identification problem where a characteristic flow speed can be measured and systematically varied. Tests using synthesized acoustic data and measured jet impingement data were used to evaluate the performance of the method. The procedure was then applied to a small axial fen typical of those used to cool electronic systems. The results added support and insight into earlier experiments related to the radiation of high frequency (f > 2.5 kHz) noise. More specifically, fluid dynamic and acoustic measurements had shown that flow unsteadiness related to tip gap flows was the primary source of high frequency noise. The frequency dependent velocity scaling demonstrated that shifts in dominant aeroacoustic processes occur near 2.5 and 5-6 kHz. Additionally, the velocity scaling analysis indicated that the low frequency regime may be controlled by sources which are not compact.

AB - This paper discusses a method for identifying broadband aeroacoustic sources. The goal of the method is to experimentally derive the dependence of sound power level upon a characteristic velocity, and to use that dependence as an indicator of primary aeroacoustic processes. The analysis provides an identification of distinct frequency bands within which the variation in velocity dependence is relatively small. As such, each band is presumed to be controlled by different processes, and the set of likely processes is fixed according to the average velocity exponent value obtained. In principal, the method is applicable to any aeroacoustic source identification problem where a characteristic flow speed can be measured and systematically varied. Tests using synthesized acoustic data and measured jet impingement data were used to evaluate the performance of the method. The procedure was then applied to a small axial fen typical of those used to cool electronic systems. The results added support and insight into earlier experiments related to the radiation of high frequency (f > 2.5 kHz) noise. More specifically, fluid dynamic and acoustic measurements had shown that flow unsteadiness related to tip gap flows was the primary source of high frequency noise. The frequency dependent velocity scaling demonstrated that shifts in dominant aeroacoustic processes occur near 2.5 and 5-6 kHz. Additionally, the velocity scaling analysis indicated that the low frequency regime may be controlled by sources which are not compact.

UR - http://www.scopus.com/inward/record.url?scp=84977138926&partnerID=8YFLogxK

UR - http://www.scopus.com/inward/citedby.url?scp=84977138926&partnerID=8YFLogxK

U2 - 10.2514/6.1996-1743

DO - 10.2514/6.1996-1743

M3 - Paper

AN - SCOPUS:84977138926

ER -

Quinlan DA, Krane MH. Aeroacoustic source identification using frequency dependent velocity scaling. 1996. Paper presented at 2nd AIAA/CEAS Aeroacoustics Conference, 1996, State College, United States. https://doi.org/10.2514/6.1996-1743