Cogeneration system simulation and control to meet simultaneous power, heating and cooling demands

Francisco Sancho-Bastos, Horacio Perez-Blanco

    Research output: Contribution to conferencePaper

    3 Scopus citations

    Abstract

    Gas turbines are projected to meet increasing power demand throughout the world. Cogeneration plants hold the promise of increased efficiency at acceptable cost. In a general case, a cogen plant could be able to meet power, heating and cooling demands. Yet those demands are normally uncoupled. Control and storage strategies need to be explored to ensure that each independent demand will be met continuously. A dynamic model of a mid-capacity system was developed, including gas and steam turbines, two heat recovery steam generators (HRSG) and an absorption-cooling machine. Controllers were designed using linear quadratic regulators (LQR) to control two turbines and a HRSG with some novelty. It was found that the power required could be generated exclusively with exhaust gases, without a duct burner in the high-pressure HRSG The strategy called for fuel and steam flow rate modulation for each turbine. The stability of the controlled system and its performance were studied and simulations for different demand cases were performed.

    Original languageEnglish (US)
    Pages899-906
    Number of pages8
    DOIs
    StatePublished - Dec 1 2003
    Event2003 ASME Turbo Expo - Atlanta, GA, United States
    Duration: Jun 16 2003Jun 19 2003

    Other

    Other2003 ASME Turbo Expo
    CountryUnited States
    CityAtlanta, GA
    Period6/16/036/19/03

    All Science Journal Classification (ASJC) codes

    • Engineering(all)

    Fingerprint Dive into the research topics of 'Cogeneration system simulation and control to meet simultaneous power, heating and cooling demands'. Together they form a unique fingerprint.

  • Cite this

    Sancho-Bastos, F., & Perez-Blanco, H. (2003). Cogeneration system simulation and control to meet simultaneous power, heating and cooling demands. 899-906. Paper presented at 2003 ASME Turbo Expo, Atlanta, GA, United States. https://doi.org/10.1115/GT2003-38840