Design, fabrication and analysis of stagnation flow microreactors used to study hypergolic reactions

Pulkit Saksena, Srinivas Tadigadapa, Richard A. Yetter

Research output: Contribution to journalArticle

2 Citations (Scopus)

Abstract

A novel method to study the condensed phase reactions that occur during the ignition of hypergolic propellants (very fast liquid reactions) using microreactors is presented. Planar counterflow microreactors are used to isolate liquid-phase reactions and diffusion from secondary gas-phase chemical and transport processes that often occur concurrently during the overall ignition process. The counterflow microreactor has made it possible to achieve valuable insight into the preignition mechanisms of hypergolic propellants hitherto not possible using conventional drop or impinging jet tests. In the present paper, the microreactor fabrication, flow field characterization, and reactivity of 2-dimethylaminoethylazide and nitric acid as hypergols are presented. Particle image velocimetry and numerical simulations were conducted to characterize the laminar velocity flow-field from which stagnation point strain rates and contact residence times along the centerline of the microreactor were evaluated. Temperature measurements at the exit of the reactor (as well as at the stagnation point) were used as a measure for the extent of the reaction or the heat released from the reaction. For the hypergols, an increase in reactant flow (or equivalently strain rate at the stagnation point) was found to initially increase reactivity, but eventually resulted in a decrease in temperature, revealing a maxima in temperature and reactivity. The trends indicated a reaction that was initially diffusion or heat loss controlled, which transitioned towards kinetic control at higher strain (flow) rates. This paper details the first comprehensive measurements and analysis of the effects of diffusion based mixing on the interfacial reactions occurring between hypergols.

Original languageEnglish (US)
Pages (from-to)2248-2257
Number of pages10
JournalLab on a Chip
Volume15
Issue number10
DOIs
StatePublished - May 21 2015

Fingerprint

Propellants
Fabrication
Temperature
Ignition
Strain rate
Flow fields
Preignition
Chemical Phenomena
Hot Temperature
Nitric Acid
Rheology
Liquids
Nitric acid
Surface chemistry
Heat losses
Temperature measurement
Velocity measurement
Gases
Flow rate
Kinetics

All Science Journal Classification (ASJC) codes

  • Bioengineering
  • Biochemistry
  • Chemistry(all)
  • Biomedical Engineering

Cite this

@article{a44afe07cb2c43abb191cd5480b7d8e0,
title = "Design, fabrication and analysis of stagnation flow microreactors used to study hypergolic reactions",
abstract = "A novel method to study the condensed phase reactions that occur during the ignition of hypergolic propellants (very fast liquid reactions) using microreactors is presented. Planar counterflow microreactors are used to isolate liquid-phase reactions and diffusion from secondary gas-phase chemical and transport processes that often occur concurrently during the overall ignition process. The counterflow microreactor has made it possible to achieve valuable insight into the preignition mechanisms of hypergolic propellants hitherto not possible using conventional drop or impinging jet tests. In the present paper, the microreactor fabrication, flow field characterization, and reactivity of 2-dimethylaminoethylazide and nitric acid as hypergols are presented. Particle image velocimetry and numerical simulations were conducted to characterize the laminar velocity flow-field from which stagnation point strain rates and contact residence times along the centerline of the microreactor were evaluated. Temperature measurements at the exit of the reactor (as well as at the stagnation point) were used as a measure for the extent of the reaction or the heat released from the reaction. For the hypergols, an increase in reactant flow (or equivalently strain rate at the stagnation point) was found to initially increase reactivity, but eventually resulted in a decrease in temperature, revealing a maxima in temperature and reactivity. The trends indicated a reaction that was initially diffusion or heat loss controlled, which transitioned towards kinetic control at higher strain (flow) rates. This paper details the first comprehensive measurements and analysis of the effects of diffusion based mixing on the interfacial reactions occurring between hypergols.",
author = "Pulkit Saksena and Srinivas Tadigadapa and Yetter, {Richard A.}",
year = "2015",
month = "5",
day = "21",
doi = "10.1039/c5lc00306g",
language = "English (US)",
volume = "15",
pages = "2248--2257",
journal = "Lab on a Chip - Miniaturisation for Chemistry and Biology",
issn = "1473-0197",
publisher = "Royal Society of Chemistry",
number = "10",

}

Design, fabrication and analysis of stagnation flow microreactors used to study hypergolic reactions. / Saksena, Pulkit; Tadigadapa, Srinivas; Yetter, Richard A.

In: Lab on a Chip, Vol. 15, No. 10, 21.05.2015, p. 2248-2257.

Research output: Contribution to journalArticle

TY - JOUR

T1 - Design, fabrication and analysis of stagnation flow microreactors used to study hypergolic reactions

AU - Saksena, Pulkit

AU - Tadigadapa, Srinivas

AU - Yetter, Richard A.

PY - 2015/5/21

Y1 - 2015/5/21

N2 - A novel method to study the condensed phase reactions that occur during the ignition of hypergolic propellants (very fast liquid reactions) using microreactors is presented. Planar counterflow microreactors are used to isolate liquid-phase reactions and diffusion from secondary gas-phase chemical and transport processes that often occur concurrently during the overall ignition process. The counterflow microreactor has made it possible to achieve valuable insight into the preignition mechanisms of hypergolic propellants hitherto not possible using conventional drop or impinging jet tests. In the present paper, the microreactor fabrication, flow field characterization, and reactivity of 2-dimethylaminoethylazide and nitric acid as hypergols are presented. Particle image velocimetry and numerical simulations were conducted to characterize the laminar velocity flow-field from which stagnation point strain rates and contact residence times along the centerline of the microreactor were evaluated. Temperature measurements at the exit of the reactor (as well as at the stagnation point) were used as a measure for the extent of the reaction or the heat released from the reaction. For the hypergols, an increase in reactant flow (or equivalently strain rate at the stagnation point) was found to initially increase reactivity, but eventually resulted in a decrease in temperature, revealing a maxima in temperature and reactivity. The trends indicated a reaction that was initially diffusion or heat loss controlled, which transitioned towards kinetic control at higher strain (flow) rates. This paper details the first comprehensive measurements and analysis of the effects of diffusion based mixing on the interfacial reactions occurring between hypergols.

AB - A novel method to study the condensed phase reactions that occur during the ignition of hypergolic propellants (very fast liquid reactions) using microreactors is presented. Planar counterflow microreactors are used to isolate liquid-phase reactions and diffusion from secondary gas-phase chemical and transport processes that often occur concurrently during the overall ignition process. The counterflow microreactor has made it possible to achieve valuable insight into the preignition mechanisms of hypergolic propellants hitherto not possible using conventional drop or impinging jet tests. In the present paper, the microreactor fabrication, flow field characterization, and reactivity of 2-dimethylaminoethylazide and nitric acid as hypergols are presented. Particle image velocimetry and numerical simulations were conducted to characterize the laminar velocity flow-field from which stagnation point strain rates and contact residence times along the centerline of the microreactor were evaluated. Temperature measurements at the exit of the reactor (as well as at the stagnation point) were used as a measure for the extent of the reaction or the heat released from the reaction. For the hypergols, an increase in reactant flow (or equivalently strain rate at the stagnation point) was found to initially increase reactivity, but eventually resulted in a decrease in temperature, revealing a maxima in temperature and reactivity. The trends indicated a reaction that was initially diffusion or heat loss controlled, which transitioned towards kinetic control at higher strain (flow) rates. This paper details the first comprehensive measurements and analysis of the effects of diffusion based mixing on the interfacial reactions occurring between hypergols.

UR - http://www.scopus.com/inward/record.url?scp=84928940888&partnerID=8YFLogxK

UR - http://www.scopus.com/inward/citedby.url?scp=84928940888&partnerID=8YFLogxK

U2 - 10.1039/c5lc00306g

DO - 10.1039/c5lc00306g

M3 - Article

AN - SCOPUS:84928940888

VL - 15

SP - 2248

EP - 2257

JO - Lab on a Chip - Miniaturisation for Chemistry and Biology

JF - Lab on a Chip - Miniaturisation for Chemistry and Biology

SN - 1473-0197

IS - 10

ER -