Effect of Surface Preparation on the Microstructure, Adhesion, and Tensile Properties of Cold-Sprayed Aluminum Coatings on AA2024 Substrates

M. M. Sharma, Timothy John Eden, B. T. Golesich

Research output: Contribution to journalArticle

23 Scopus citations

Abstract

Commercially pure aluminum coatings (CP-Al) were applied to AA 2024-T351 substrates utilizing the cold spray process using different surface preparation methods and carrier gases; the resulting microstructures and mechanical properties were investigated. Substrate preparation methods were examined to understand the effect of substrate roughness on coating properties, to minimize embedded grit, and to identify the surface preparation method that yielded the best combination of coating properties. Three substrate roughing preparations, glass bead, SiC grit, and alumina grit blast, were examined while utilizing both helium and nitrogen as carrier gases in the cold spray process. Coatings that were oxide free, possessing densities greater than 99% were achieved, with the mean coating porosity ranging 0.1-0.5%. The highest mean adhesion strength was 42 MPa for the nitrogen gas and 20 MPa for the helium gas, both using glass bead surface preparation. For the nitrogen process gas samples, the surface preparation methods that produced high pull strengths correlated to bend test specimens that showed no signs of cracking on surfaces or edges. The overall best combination of mechanical property results was achieved with coatings prepared by glass bead surface roughening using nitrogen as a carrier gas.

Original languageEnglish (US)
Pages (from-to)410-422
Number of pages13
JournalJournal of Thermal Spray Technology
Volume24
Issue number3
DOIs
StatePublished - Jan 1 2014

    Fingerprint

All Science Journal Classification (ASJC) codes

  • Condensed Matter Physics
  • Surfaces, Coatings and Films
  • Materials Chemistry

Cite this