Measured adiabatic effectiveness and heat transfer for blowing from the tip of a turbine blade

J. R. Christophel, E. Couch, K. A. Thole, F. J. Cunha

Research output: Contribution to conferencePaper

4 Scopus citations

Abstract

The clearance gap between the tip of a turbine blade and the shroud has an inherent leakage flow from the pressure side to the suction side of the blade. This leakage flow of combustion gas and air mixtures leads to severe heat transfer rates on the blade tip of the high pressure turbine. As the thermal load to the blade increases, blade alloy oxidation and erosion rates increase thereby adversely affecting component life. The subject of this paper is the cooling effectiveness levels and heat transfer coefficients that result from blowing through two holes placed in the forward region of a blade tip. These holes are referred to as dirt purge holes and are generally required for manufacturing purposes and expelling dirt from the coolant flow when operating in sandy environments. Experiments were performed in a linear blade cascade for two tip gap heights over a range of blowing ratios. Results indicated that the cooling effectiveness was highly dependent upon the tip gap clearance with better cooling achieved at smaller clearances. Also, heat transfer was found to increase with blowing. In considering an overall benefit of cooling from the dirt purge blowing, a large benefit was realized for a smaller tip gap as compared with a larger tip gap.

Original languageEnglish (US)
Pages251-261
Number of pages11
Publication statusPublished - Dec 22 2004
Event2004 ASME Turbo Expo - Vienna, Austria
Duration: Jun 14 2004Jun 17 2004

Other

Other2004 ASME Turbo Expo
CountryAustria
CityVienna
Period6/14/046/17/04

    Fingerprint

All Science Journal Classification (ASJC) codes

  • Engineering(all)

Cite this

Christophel, J. R., Couch, E., Thole, K. A., & Cunha, F. J. (2004). Measured adiabatic effectiveness and heat transfer for blowing from the tip of a turbine blade. 251-261. Paper presented at 2004 ASME Turbo Expo, Vienna, Austria.